carterb23
carterb23
Hello Simon - Thanks for your comments! Start-up beeps: When I compile the source with UART disabled (PWM enabled), I get the standard start-up beeps and the ESC works as...
Hi Simon - Thanks! Changed fuses and now it works. Low pass filter was already removed! Two more questions: 1. Can I simply change baud rate to 115200 without any...
Hi Simon - I could get UART with 115200 working but following changes were necessary. I found hints on the Internet. Is this the proper way to change baud to...
Hi - Thanks for your remarks! Did you try higher baud rates with that board? Cheers, Oliver
Hi again! Ok, I will give this a try. From the data sheet, higher baud rates should be possible. My host CPU can achieve 1 Mbit/s easily. Do I need...