campbellcopeland

I use the Charge Low Power setting already - it’s an equivalent for discharge that I’m interested in.

To be fair, I’m not sure if there are advantages to a reduced rate of discharge or not. Unsure if this is beneficial for the BMS to calibrate SOC compared...

I don’t think this is quite right. Earlier today it planned multiple iBoost sessions when rate was more than gas, irrespective of scaling used. Tonight, it caused an empty plan...

Logs attached but one thing I notice is the previous gas rate warning - my sensor is called sensor.octopus_energy_gas_e6s15528222161_1040333105_previous_rate but PredBat is looking for sensor.gas_e6s15528222161_1040333105_previous_rate Turning on iBoost removes current...

I’m on agile so only planning iBoost to trigger my automation for Tuya immersion control when rates are cheaper than gas - just now, agile hasn’t dropped low enough for...

@gcoan i don’t have an Iboost, just a Tuya enabled switch for my immersion heater that I have an automation to trigger whenever Predbat sets the appropriate flag. So, it’s...

I spent under £40 to replace my existing fuse spur with something similar to this. couldn’t justify the cost of a proper solar diverter due to export rates vs Octopus...

@Vinutham18 I've got nothing to do with the project other than following - I’m not an owner or reviewer, just adding comments to this issue.