bsculley

Ok, I see from the code that X, Y and Z steps/mm are $0, $1 and $2, but when I send $$, I am not getting the list indicated in...

Ok, thanks. But the code referenced is a part of GRBL, not part of the Arduino sketch. How can I apply any changes to the stepper controller module? Is there...

So how can I make it work? From: EeeeBin Sent: Friday, August 30, 2019 11:31 AM To: m5stack/M5Stack Cc: bsculley ; Author Subject: Re: [m5stack/M5Stack] Stepper motor module not reporting...

Sorry to have offended you. It seemed to me that some other issues dealt with deficiencies in the library rather than actual bugs (enhancement tag). In any case, I have...

Here's the GEVCU log starting from an 'a' reset. At the end, the DATATYPE=2 error repeats forever. I tried to run some of the samples included with the library, but...

I have not updated the firmware on the BLE module. It appears to be an OTA update, but the device is not providing any Bluetooth connection. I'm getting groups of...

Further to this issue, I have managed to connect to the BLE device using the Adafruit android app. I see the device being advertised as GEVCU 6.2 ECU, but the...

I have asked about it on the Adafruit forum. Maybe I'll get an answer. Can you confirm a version of the firmware that works with GEVCU? The module I have...

I bought a new Bluetooth module and am getting the same results as before. Device software is revision 0.6.5. Should I upgrade it? I really need to get this working....

I downloaded and installed the Adafruit library. Nothing much changed, just a new error. I'll try the DEV version of GEVCU tomorrow. Are most of the changes to the AdafruitBLE...