Brett Daman
Brett Daman
Dear, thanks for the help. I dont believe it is a wiring problem since the problem can be perfectly replicated. A new development: It seems that if my device stopped...
bump, did not find a fix yet!
And your problem is gone? In my case its very unlikely to be a wiring problem. The problem is very repeatable and consistent. All works fine if i push the...
Just to be sure I flash the basic setup comments for all my motors and all my axes each time when my application code starts. And just after that I...
My software waits a few seconds, I see the status chance long before I move on in code. So that cant be the problem. And the parameters are read perfect....
I worked around it by resetting the boards "CTL-X" before homeing. But it is still an issue that should be solved.
@jrcandy This is an issue from 3.5 years ago, I don't have the hardware anymore to test. Behavior was unexpected when executing a second homing so it could be related....
+1 got the same error for yuyv webcam
related to https://github.com/bellbind/node-v4l2camera/issues/34
No 2 clocks are equal. So one node will have a different time as the other if you don't have regular syncs and even then you will notice the drift...