bobybobybob
bobybobybob
it is less difficult to solder the Flash component. Then solder on the circuit board of an ESP01, put Tasmota on it, unsolder it and put it back into the...
I have two of these adapters. One broke when I took it apart. From this broken one I unsoldered the flash module. From one ESP01 the flash component was desoldered...
https://s12.directupload.net/images/201115/uf5v5zdj.jpg
yes the problem persists... even compiled for esp8266 i have to do it again manually via the respective web interface.
I have found out in the meantime that when the program says that the update was successful, the corresponding Tasmota end devices are not yet finished with phase 1 where...