bobf41

The [Meteolis ](https://www.amazon.nl/somfy-1810619-aandrijfgroepen-besturingssysteem-3660849545673/dp/B07KTPMGKL)is the central system which controlls the wired motors. It receives the RTS remote signals and lowers or highers one of the connected motors. So basically instead of...

Ok, I did check registering the normal remote again, this is fine, press program button on the back and it is picked up already. The crystal is properly installed and...

Just attached the AMP meter, and I see current flowing when cammands are send, when I pull the data cable this stops so wires are good. Even tried an antenna...

I put a multimeter in series of ground so can measure the current which is flowing in mA. Just created a secondary one with the R433.4 Crystal on it and...

Attached it to a multimeter. Tried repetition of 1-5 and 16 written in the other post and restarted Pi-Somfy in between

Tried Thijs code directly but without succes. Perhaps it is some other code at my side off course. Or the meteolis just binds differently although normal RTS remotes can be...

Having this issue as well on an electric gate with Shelly 1 plus. The SW port is connected to a 24v ground connection L is ground and N is the...

> Having this issue as well on an electric gate with Shelly 1 plus. > The SW port is connected to a 24v ground connection L is ground and N...

I had the same issue with a gate opener. While moving I got a "flashing" signal, when stopped and open it was a continues signal. I have added a small...