beikeland

Same here. Using a SN65HVD230 module, built in 120ohm termination, Rs=10k sets the chip to slope control. Might have a go at replacing the 10k with a short to ground...

> Ta-da This is awesome, sad to see the having to physically press a button limitation is still a thing. Is there any work out there for a custom firmware,...

Thanks for the insight! Disassembly done; base contains power supply, relay and buzzer, temperature sensor. Inside handle (under touch buttons) there is a small board with 2x 3pin connections to...

Completely get that @aprosvetova , and there is likely a lot of people who would be very grateful. I figured I'd look into physical access in the off chance the...

> My goal is to connect two different home assistant setup's/networks which are some kilometers apart. Have you looked at the duty cycle limits for the 433mhz band? You might...

> I suspect something might be up with `PosixSerialPort.cpp`.. but I have not tried on Linux honestly. Anybody else noticed the same behavior? I've flashed a ATSAME70x20 using bossac from...

Over on the Duet3D forums there a even a few cases of windows failing in a seemingly similar manor, unsure if usb cable issues or the same underlying problem. (confirmed...

see https://github.com/shumatech/BOSSA/issues/71#issuecomment-415997591 although I was not successful with current mingw, will update if i find a workaround or how to install the specific version.

there is also a make target for just the command line version that has less dependencies `make bossac`

Uploading single files would certainly be easiest with wget/curl and a webserver. Using espota.py requires the whole SPIFFS image to be built and sent which will overwrite existing files, takes...