bear-gha
bear-gha
> The absolute pressure reads ~101kpa as it does on the 'Car Scanner ELM OBD' mobile app. The MAP sensor reads ~97kpa per the same app (iginition on, engine not...
@AussieMakerGeek I think this is not 0x0B in CarScanner, if you select this sensor in Sensors list. You can do this - select only this sensor in filter as active,...
@AussieMakerGeek with that cut log i can't help. Need log as i said.
@AussieMakerGeek yes, in log 58, if in sensor filter only "Intake manifold absolute pressure". Value in kPa. This PID in App do not use any formula, except scaling (if not...
@AussieMakerGeek No, not an app developer, just a researcher. Can you go again in Sensors, then select active profile - OBDII, same value? Value also check only on Sensors page.
@AussieMakerGeek Settings -> Sensors -> On the top right, click on profile "Basic OBDII" -> On the left click on loupe (filter) and write "Intake manifold absolute pressure" -> Same...
@AussieMakerGeek Not like this? And for value question is open. 
@AussieMakerGeek With "all" you can see values from other profiles, not only from Basic OBD, need click on Basic and compare value with log, also write value from ID 11...
Can you change this kPa, with new value, and give value from log? Need another pair. (need full string from log, not only 1 element).
If you change this parameter, there will be a different value of the line in the log, you need a new pair to analyze.