bbum
Oh! Thanks! The Universal Box is really hard to understand. Too many knobs and it isn't obvious what they do. Without examples of each, it is hard to figure out....
I haven't yet dove into the programming language enough to write such a pattern. I'll try to give it a shot when I have a moment, but am hoping someone...
This is what I meant. This snippet does two things; - ensures that the RGB ordering is correct. Should be 2 seconds of red, then green, then blue. - puts...
Thank you. In general, it seems that a lot of the "install latest Marlin on Ultimaker & do a tuned, fast, clean print" references are out of date. I'm happy...
I'm about to publish a new article to my weblog all about updating to the latest firmware on the Ultimaker & comparing print qualities of various slicers. This: http://daid2.mine.nu/~daid/marlin_build/ Changes...
Thank you @CZDanol. I believe you are correct. I'll test it out this eve and likely close this as "Guido's Time Machine wins again" (a Python thing).
> Hello. If I understand you correctly, this is what the toolmapping screen actually is for. You select the "G-code filament 1" on the left side, click on the knob,...
@Jan-Soustruznik To confirm: There appears to be no support for multi-material printing with sequential printing. Or, more specifically, if each object is printed with a different material, then the tool...
> I'm interested in following this because I just ran into problems today with my first attempt at using sequential printing. I'm using PrusaSlicer 2.9.2 with a 5T XL. My...