Andrew Zaborowski

So just to document my findings so far and some possible ideas, I tried the methods documented in this project on my 2013 Qashqai J10 (versions E607, hw 034) which...

FTR the LCN1 uses a different SoC, an OMAP5948, something made by TI specifically for Bosch headunits, according to the internets. So none of the LCN2 tricks are likely to...

Bad news for anyone hoping to do anything fun with LCN1 head units: they don't seem to run Linux. Personally I'm giving up on it but leaving some notes here...

Could it be that the unlock code is simply different now? I bought my cards from the aliexpress seller that you link on https://richard.burtons.org/2016/07/31/cid-change-on-sd-card-update-evoplus_cid/ this week but the cards look...

BTW the date part of the cid is March 2018

Hej, 2011/6/26 rhn [email protected]: > raczej trik na przyszłość dla siebie - bardziej uniwersalny, mniej bezpieczny kod. overflow_occured nie musi być sprawdzane atomowo. nie wiem, czy się nada tutaj, ale...

I had not noticed this discussion and started adding a similar thing myself, https://github.com/balrog-kun/tgy This uses a serial two-pin protocol for writing the throttle value (8-bit) and reading the number...

Ah, yeah MOTOR_DEBUG would have worked now that I understand what it does.. Only downside is I'd need one pin per motor instead of a single "bus" type of thing....

So my host code is quite ugly, but anyway: https://gist.github.com/4516478#file-motor-test-serial-c-L24-L264 is for testing on Arduino and it assumes both the ESC and the Arduino run at 16MHz. MOSI & PWM...

Good point about the counter increment, I did the cli/sei thing and moved this operation to some place where it only runs once per the commutation sequence instead of 6...