Alex Wright
Alex Wright
Thanks. the major thing I need to know is if the nrf modules aren't populated will it cause issues with the pcb. Where did you have the boards built as...
I have a cm4 sitting for the purpose of using it as a flight controller. the pcb would work for me for the most part. I would end up using...
I know you have been busy, did you get a chance to add testing of motor outputs? I also had the pcb manufactured just need to add components. Is there...
> Finally finished ! > > If you don't already have a working setup, you can find a prebuilt image here : https://github.com/dridri/bcflight#pre-built-images. This should be ready to use without...
> My process on ICs like IMU1 is as follow : > > * use low temperature soldering paste > * roughly apply it on the pads > * pre-solder...
> @awright424 here are some pics of my board so far. Just note that I'd actually recommend against soldering the header pins for the battery power line, as it will...
Also is the bom generated with the pcb way tool correct?