avxmw

For some reason the cam works in OrcaSlicer if I set it up as http://ip:4409/webcam/?action={snapshot,stream} but not if setup as http://ip:8080/?action=stream while in Firefox both work and even in parallel.

@padcom Indeed, changing moonraker.conf to have `mjpegstreamer-adaptive` also gives me a picture in OrcaSlicer. Thank you for this, works as a workaround. However I would not call this a fix...

Sure, output as done by PS: [Buckle-Bottom-ps.gx.txt](https://github.com/Jacotheron/FlashForge-CreatorPro2-PS-Profile/files/12892557/Buckle-Bottom-ps.gx.txt) output after conversion with your script: [Buckle-Bottom-conv.gx.txt](https://github.com/Jacotheron/FlashForge-CreatorPro2-PS-Profile/files/12892568/Buckle-Bottom-conv.gx.txt) When you ctrl+f for "m104", the hit after changing to layer 1 is the problem.

Thanks for the insights. From my understanding, that should only happen in "left extrusion only" mode since the right extruder is T0/default and is actively controlled in every other mode....

I'd guess the simplest way would be to have a local web page and some JavaScript where you can "paint" squares to make your form and then generate a list...

 Only value changed is d_wall from 0.95 (kennetek default) to 1.2 (Zachs default). It has something to do with the lip. With lip removed it works, with lip set...

Interesting, somehow I remember 1.2 and it made sense on a 0.4 nozzle. As per your suggestion, indeed, setting d_wall = 2.4 and slicing it with the same settings results...

Only tried .5 units so far since I think that is reasonably easy to fill the grid with and staying flexible. I prefer odd-size boxes over wasted space. I'll keep...

Regarding #107 it gives me holes on 21mm boxes. However the holes slightly overlap and are thus not usable with the common 6mm magnets. I don't know where the `d_hole_from_side=8`...

I'd say anything smaller than 21mm is highly unlikely to make sense, maaaybe 14mm if going for 1/3 2/3 boxes. With boxes that small only a small amount of weight...