asapreta

> I downloaded my images from https://mirrors.apple2.org.za/Apple%20II%20Documentation%20Project/Interface%20Cards/Disk%20Drive%20Controllers/Apple%20Disk%20II%20Interface%20Card/ROM%20Images/ Thank you, I thought I need to be something diferent (code or so) to use on regular EEPROMs!

> The jumpers just go directly to your eprom's extra address lines, A8, A9 and A10, and you set them high or low to select the region of the eprom...

And, I don't know why this project isn't popular. Do people think it won't work?

My main doubt was about the code to write in the EEPROMs as they are the same of the PROMs I will send the gerber to create the board and...

> I have built and tested my board, and it doesn't work without some rewiring, which I added to the wiki here: https://github.com/btb/DiskII/wiki/Revision-0-errata > > After rewiring, I tested it...

> No changes needed to the firmware, just make sure you set the jumpers A8 A9 A10 as appropriate (i.e. all LO, assuming you put the .bin files at offset...

> Revision 1 is now, done, with gerbers here: https://github.com/btb/DiskII/releases/tag/rev1 Thank you very much. I will make a batch for me. There are some APII needing them here!

> Hello from Ireland, I have ordered few PCB rev.1 but unfortunately didn’t work for me. When I power on my Apple IIe the computer beeps and jumps on the...

> As our friend had problems with the jumpers, is It possible to creste a table of their positions/selection? Thanks in advance