Andrea Palazzi

Additional info: Arduino IDE 1.5.4 ; when compiled for Arduino Mega 2560 it works.

I didn't specify any flags while compiling Simbody, the build system did all the job; moreover neither the readme nor the document linked at "you want to... use simbody in...

``` andrea@navicella:~$ lsb_release -a No LSB modules are available. Distributor ID: Ubuntu Description: Ubuntu 18.04.1 LTS Release: 18.04 Codename: bionic andrea@navicella:~$ gcc --version gcc (Ubuntu 7.3.0-16ubuntu3) 7.3.0 Copyright (C) 2017...

Hi, I also have a mixing printer and I'd like to test this feature, is it already merged in the main branch? How can I build and test this feature?

I've run a test and the result is the same as with par2cmdline: the file is not repaired and, to be more precise, the "repaired" file is the same as...

I noticed that it needs a lot of memory ;) but if it runs out of memory usually either the process is killed and the system reports it, or the...

Here are the results of the test with only one file: Loaded file description packet for "Full-0005" (ID=0be49d13888f6c69ea09b2307d58f0dd, 19327343417 bytes) Loaded checksums for file with ID 0be49d13888f6c69ea09b2307d58f0dd Loaded main packet:...

Yes, more output is welcome :) also, if I understand correctly, gopar overwrites the original file with the corrected data: maybe you could make it write a completely new file...

par2cmdline overwrites the original file, but in the end the repaired file is not changed. I'm not sure I understood your theory. Note also that this is not the only...

@mdnahas Don't worry, the data should be safe (but see below), I was just double-checking if everything was ok with the backup. @akalin the file is a bareos backup file,...