andreishabo

Hi Martin, Thanks for the provided information! It is truly useful and very interesting! We have built an EVCC controller (from V2G) based on Raspberry Pi 3 + QCA7000, and...

Hi Martin, We use DC charging session, there are no SLAC messages appearing. Also while connecting to the car there was nothing happening with the tshark (sniffer) and we were...

Hi Martin, We have connected it successfully to the car and getting SLACK messages and a short connection notification following a disconnection in 10 seconds. Then we realized that the...

Dear Martin, Thanks for the provided update and information! We will try to configure this thoroughly. We were able to connect to BMW I3 DIN 70121. Currently, we have a...

Hello Martin, I am sorry for the late reply. I have gone through COVID during my vacation recently. However, as for the project. I decided to use [RISE V2G Clarity]...

Martin, I have found that Open V2G is a tool somewhat similar to EXIficienet codec that is used in RISE V2G. Instead of EXIficienet codec, we can use OpenV2G to...

Hello Martin! Thanks for the response and provided information with the video! To update you, we have reconfigured RISE V2G code to DIN standard and tested it on BMW car...

Hello Martin! Thanks for your advice! In `ChargeParameterDiscoveryReq` we already get the error status `FAILED_ChargerConnectorLockFault`. After `ChargeParameterDiscoveryRes` we recieve `PowerDeliveryReq` with `FAILED_ChargerConnectorLockFault` instead of `CableCheckReq`. Then the vehicle sends `SessionStop`...

Hi Martin! I hope you are doing well! > Does the car actually perform the cable lock? Actually not really. Let me explain: When I plug the cable into the...