Adam Kadlec
Adam Kadlec
Maybe my question a bit chaotic :D Right now I'm using TSA with sync ack. Master is pooling every single slave and reading their registers, similar to Modbus. Each slave...
Hi @gioblu thanks for you reply. So KNX style of communication with TS or TSA is a bad idea?
Hmm right now I'm locked to use TS or TSA in v12. So there is no way how to detect by slave if bus is ready? I'm thinking about mixed...
Hmm....so in that case, I'm thinking about creating another device which will act as a proxy between PJON devices and RPi master. Because right now I'm locked into V12 and...
@EternityForest so you are using MCP2515 with PJON?
Hi @gioblu, thanks for you reply. Right now I'm not able to configure timeout :/ on rpi I'm using `PJON_cython` and this port does not support this configuration :(
Hi @gioblu So I did some other tests on my dev env. Just to be clear, my master is RPi with `pjon_cython` v12 using TSA and right now one slave...
Hi @er1z have you figured out how run PJON on MicroPython
Or is better idea to have anoter arduino as a proxy, where will be "master" sketch for the pjon network and rpi connected via serial link to aurduino?
Hi @gioblu thanks for your reply. I will try to start with an example code from this repo. And what do you think about the rs485 and TS? I saw...