aepoc

I believe it may be a while before we see variable resolution in 3D. The team is working very diligently to make this happen but per one of the presentations...

I've managed to get several 2D simulations to work as expected now. I am currently working on the more complicated geometry (.stl), still in 2D. For both the inlet and...

Anyone out there know how to impose an outlet on an inclined plane? The inlet was created with a horizontal drawbox face... I attempted the outlet the same way which...

Okay; I am still battling this simulation... There are two inlets and one outlet. My geometry is basically a sluice with a slope of about 13 degrees and a flat...

Thanks for the tip. I will look into this when I get back to that particular simulation... thankfully most of the simulations I have been running so far don't require...

> @aepoc could you make some progress with the rapid surf facilities you are simulating? We have simular issues, maybe we can get in touch and exchange knowledge? for example...

Hey There Sohail, I was able to draw boxes (make sure they are not too close to your boundaries). Add to simulation as a fluid type & face fill mode...

Ansys and FEA tools in general are a very different beast than SPH... I've only used Ansys for a short time but basically had to forget the majority of what...

Seems to be working as I intend now. I'm not exactly sure what I did correct... perhaps it was putting the plungers below the bound geometry in object order? I...

I would just like to note that changing the start time of the paddles in the casedef.xml was much easier than changing the starting phase in designsphysics