WyndStryke

Just noticed in the modbus protocol document (20240516, v1.05) that it lists 46000-46020 as the remote control registers, and doesn't mention the 44000 range. On my KH >1.33, 44000-44002 seems...

Regarding this earlier comment: > As I recall there may be a problem with reading the Remote Take effect register as the KH did not expose registers above 44003 -...

Should point out that force charging / discharging all work fine via the integration on my KH, without needing assistance from automations, it's just reading the schedule or work-mode if...

Firstly make sure that the app does not have the mode scheduler enabled, otherwise they will be fighting for control. Once that is turned off, then predbat should just work,...

> I'm now 100% convinced this is the issue. The issue in this thread was resolved some time ago, so unless you have an old version of the integration, or...

> 2\. Between it "not working" and "working" I have used the Schedule function of the Fox app for the first time ever (and then turned it off). This is...

I can see that the time is drifting further on mine (8 February 2025 at 23:12:32 versus inverter 25/2/8 23:14:27), about 4 seconds per day. The inverter is online, has...

The following does not work, so don't try using it, but I'm not sure why it doesn't work (very much a HA/yaml newbie). It is dropping out at the 'safe_to_update'...

Many thanks, I think I'm a lot closer now - one more issue I also don't understand. It runs all the way through, but seems to fall over in write_registers....

Apologies for so many newbie questions, it works perfectly now, thank you :-) No more worrying about clock drift. I had a couple of my automations go wrong last night...