Bill Brothers

Splitting configurations has a challenge in that any part of the configuration that requires save_config to write to the bottom of the printer.cfg fails if that value is any other...

I have installed 2.1.2 on one of the two boards received from KB-3D.com (US Vendor) and wifi has been running well for about 4hrs thus far. I have been playing...

Has anyone found a way to read what version the hardware is with software? Also the scripts used at startup log cleartext credentials for SSID/password to /etc/scripts/wifi.log. Take a look...

> Has anyone found a way to read what version the hardware is with software? Also the scripts used at startup log cleartext credentials for SSID/password to /etc/scripts/wifi.log. Take a...

Apparently they broke the network driver in 2.1.2. If you comment out everything in /etc/rc.local, their scripts will stop killing the wifi every 5 seconds (and will stop the blinking...

Installing with kiauh correctly chooses the users and changes the scripts to use biqu user. The only permissions problem I found was the root-owned gcode directory (which one can remove,...

The biggest thing I see is that the xwindow system is not running at all. I suspect that the desktop components are missing because the octopi image is built without...

I have been running **32-bit** (waiting to take on yet another early system). For that I have published a my work-around for the 32-bit space. See https://github.com/TxBillbr/octodash-hyperpixel-fix . the 3Dprinting...

I upgraded to 5.4 kernel and the solution breaks. Here are the dmesg lines for Goodix... [ 5.366547] Goodix-TS 11-005d: 11-005d supply AVDD28 not found, using dummy regulator [ 5.366659]...

Same problem as @mikenosko. Only difference is pi revision C03111 For grins I did an rpi-update to the commit that bumped the kernel to 4.19.118 and the screen runs correctly....