Treehee
Treehee
You make a valid point when it comes to scissors, but not for knifes I think. Overall, It should probably be a setting. *Alternating tabs improve glueing by sort of...
Wouldn't it then be more useful to straight up print the angles on the edges? Like negative degrees for mountain folds and positive for valley or smth.
I'm currently digging into this, and I wonder; is there anything other than surface speed that I should let the user choose (when working with laser cutters)?
I meant what variables are important for the user to set while exporting? So far I came up with; surface speed (in m/min) feed rate (not entirely sure what this...
@alpharesearch are laser cutters able to cut at an angle?
@alpharesearch with feedrate I meant G99 and could you explain to me what it actually does? CAMotics throws an error if I don't define a feedrate. - seems like a...
Ooooh engraving would be usefull for the numbers, arrows, and other text
@alpharesearch I was already using that link 😄 And yes, G99 is feedrate per revolution - it's the same thing you can set on G00 and G01, except it makes...
@alpharesearch I did some more research and G96 doesn't do anything on laser cutters (or milling machines) as both already have a constant speed so I will just use G97...
That also means I will use G94 to control feedrate