Tomas Chladek

Yes, it is fine, at the moment, the printer is printing from USB drive. Looks like, it is independent from WiFi connection. I uploaded `gcode` to printer when no USB...

Yes, I am able to access the PrusaLink only after every WiFi module firmware flash. When I turn off and on the printer, I am getting always the `ERR_CONNECTION_REFUSED` message.

These steps are always reproducible in my case 1. Network -> WiFi -> Set WiFi module 2. Open IP in browser and set API key -> Success 3. Turn off...

The printer is showing completion time, not remaining time, so the printer is online and knows current time. But I can not connect to PrusaLink.

I tried to flash WiFi module firmware again and I am still not able to connect to the PrusaLink. Wifi icon is white and the printer is showing print completion...

Two WiFi modules ordered from [Aliexpress](https://www.aliexpress.com/item/32809618395.html?spm=a2g0o.order_list.0.0.31211802v7PAip) and two printers with different Buddy board version. Version 1.0.7 is OK, mine (1.0.5) is not working. Unfortunately, I cannot try my module on...

There is around 9 600 km between these two printers. I have ESP-01S and the printer is able to download current timestamp and I have been able to access PrusaLink...

I have new WiFi module from another recommended seller and there is the exactly same behavior as before. I can access PrusaLink only for the first time after flash WiFi...

I tried mobile hotspot. It works only for the first time, close and reopen browser tab and PrusaLink was dead. I tried to load hotspot settings many times but Prusa...

Footer is nice, but it would be even nicer to see filament and sheet also in web page. This feature request is about web page.