StuweFPV
StuweFPV
I don't get 1000-2000 and that's the issue. As mentioned above the servo way is limited to 75% so i only get about 1750 instead of 2000. (the mixer is...
Sorry if i was not clear in my description. i never limit, trim or change anything on my transmitter. I do the settings on the Output page. My current file...
I did check the values comming from the receiver and they looked ok. not perfect on 2000 but somewhere around 1970. however i found that for some strange reason the...
ok thanks - then at least i did that correctly :) but in the end does it have any effect or influence any automated modes or pid's or whatever if...
I agree with dingrgh - I don't have any compass/magnetometer on my planes and everything works just fine. My GPS modules don't even have one (I use mainly BN-220) and...
Roughly 1 out of 20 times i activate WP inav 4.1 will not go into WP but some strange WRTH mode (I'd have to look it up exactly next time)....
Today i was testing some antenna setup with my test plane and did about 10 flights. Running 4.1 on a F722-Wing and CRSF. Now and then I test RTH in...
> Startup screen is arming screen or something else ? Yeah sorry meant "arming screen" where it now reads "mission loaded" which is super handy > Was this a single...
> @StuweFPV Can you open a new issue for the crash problem. Needs special attention if it was an FC lockup caused by a bug. Ok done #8055 - Thanks...
yes that is correct. I set failsafe as a mode and define the RTH procedure as the failsafe action. Crossfire is set to cut. worked well on over 40 planes...