Slypty

Thanks for the tips. I tried logging in to my modem, but the gbscontrol IP doesn't show up in the DHCP Client list. When I try to connect to it,...

That can't be right, the phone I'm using doesnt have a SIM card. I'd suspect my ESP8266, but I've had the same results twice with two different ESP8266s. On Sat,...

I don't t doubt the board can be used, maybe I've overlooked something with the install. Here's some pics of my install. Does the blue led light up when you...

It is getting power. The pic above doesn't really show where the red wire goes to, but I do have it connected to the VCC pin. If I was just...

Well the GBS works fine with my Wii (component to VGA). So I've ordered another WiFi module, considering it's being powered and I see a WiFI link for it, the...

Figured it out. Maybe specific to my PC, not sure. The idea of adding libraries to Arduino via extracting the .zip to the Libraries folder wasn't working properly. The correct...

Another thread hasn't been created, I might post as a compilation error if the fix works for you. As mentioned, at least what my issue was that adding the libraries...

Probably the easiest way is to take the H/V from VGA and combine with the schematic from this tutorial: https://www.retrorgb.com/building-a-passive-sync-combiner.html?fbclid=IwAR3MXHjSig9jMJoKDikI2rEI6iaGd9T380cCAQcrfmUoduySPhyCRVaPUWs I have to do the same myself with an NTSC...

The issue is that the RP2040's I bought have a slightly different pinout. In place of GP4 this design uses 'G' on Pins 6 and 13. Look out for boards...

Thanks, I have the AVR Boards and LUFA Leopard as the selected Board. Before I installed to the most recent IDE, the headr wasn't being found. There seems to always...