Serios

Hi @CaMer0n this happens when add/edit WM and News, Tinymce is installed and activated. I'm adding standard img tags after save, they get converted to [img] .... [/img] I think...

Hi @jcastro with address set as 0x77 the log returns ```` [11:29:32][C][logger:233]: Logger: [11:29:32][C][logger:234]: Level: DEBUG [11:29:32][C][logger:235]: Log Baud Rate: 115200 [11:29:32][C][logger:236]: Hardware UART: UART0 [11:29:32][C][i2c.arduino:037]: I2C Bus: [11:29:32][C][i2c.arduino:038]: SDA...

> I think this is the problem `[11:33:27][C][i2c.arduino:046]: Recovery: failed, SCL is held low on the bus` Can you try changing SCL/SDA pins to for example 16/17 (on ESP32) I...

Just updated to version 2022.2.6 and the issue still exist. Even tried to clean build files first and then recompile again, results are the same

I have my instance installed in venv and couldn't find any info how to downgrade to previous version of epshome. Since my home heating system depends on automations based on...

@shakin89 @jkeys1989 try adding "scan: false" and "id: bus_a" parameters to i2c section and "i2c_id: bus_a" to platform: bme280 in config also update esphome to the latest 2022.6.2 ``` i2c:...

@jkeys1989 check your wiring and also make sure that sda and scl are set to the proper pin numbers, also try to use 0x76 address in bme280 configuration. I don't...

@jkeys1989 Do you have by any chance a spare BME280 module to test with, just to take out the possibility of faulty module out of the equation. Otherwise I'm really...

@jkeys1989 I'm glad you sorted it out, usually my go to rule when ordering some cheap modules is always buy+2. That way there is always a spare module, just in...

I can confirm that all the widgets regarding system performance are still throwing this error.