3DPrintColorizer
3DPrintColorizer copied to clipboard
Sakati84
Software & Hardware to do multi color printing with Sharpies
Would it be possible to extend the plugin to support using the Sharpie as a release agent for support structures? Check out this video, which shows how you can use...
The first layers will be laid fine but later on it will be pushing against the print and flexing the springs of my bed, and grind against the print.
I'm trying to fix it by writing a wiki myself but you can't PR those, unfortunately. You can clone it on my fork with this link: https://github.com/Nathan22211/3DPrintColorizer.wiki.git Mind you I'm...
I don't know if it's possible, but is porting this to PrusaSlicer viable? My Ender has really bad layer shifts with Cura. I'm not a developer so have no idea...
I'm new to 3D printing so I apologize if I'm making a newbie mistake. I'm using the stock firmware on my Ender 3 v2. I've followed the instructions as closely...
This way the markers can be grabbed, but you can still print at their full height. Should fix issues with some direct drives as well
This should be doable on most gantry printers, as that's usually in the middle of the printer, but this will require calibration for the other side with a Y cord...
I need Help. My Cr-10-V3 sets the Temperature at beginning to 150 and don't extrude. This behavior doesn't change in the whole print. The Printer do the right movement. This...
I've been trying and wanting to use this, wiht my CR6 SE, as I haven't gotten my Ender 3 set up properly, though I have a EZABL I could potentially...
