Robin-SeaThrough

Regarding Spindle RPM, could it possible to have two boxes for the Spindle RPM? As in one input box (Requested or Programmed RPM) for manual entry and showing what the...

@terjeio is probing.Offset used for anything other than the distance between 2 points along an edge when using Rotation probing? If it is, I would very much prefer if that...

> The first issue is likely due to the tool offset beeing reset when the Stop command is sent. I have changed this in the last commit. Both the tool...

> > It is, new [fix commited](https://github.com/grblHAL/core/blob/master/changelog.md#20250220). Thank you very much for the quick turnaround! The update sounds very promising! We discussed this a bit yesterday evening over on the...

Thank you for the reply Terje! I understand, it definitely makes sense to make sure the behaviour is in line with NIST! The problem as I see it isn't really...

> BTW is jerk acceleration enabled in that version? As far as I can see, and from what Andrew Marles have said earlier, no, jerk acceleration isn't enabled in this...

@terjeio Thank you for the very quick response on this issue! The changes you made, was that only in the STM32F4xx driver or the Core as well? I saw that...

As @WhatsUGonnaDo eluded to, I ran his Gcode program earlier today, with the FlexiHAL 1.0.1.3 firmware, without SD card or Network enabled, so that's with the 20250223 grblhal core. And...

That sounds like progress to me, that you're able to replicate the lost steps with an STM32F4XX driver :) A few of us have been discussing this over on the...

 > I believe I've fixed it now... Sorry for causing problems. Thank you Terje! That sounds like something that could cause a drift for sure, and it I believe...