retroninja
retroninja
If you mean a selector that turns DF1 into DF0, then no. The DF0 select line isn't available at the external floppy port unless you reroute it internally. Even if...
1. It has to be modded for Amiga first. 2. You can connect another adapter on the 24 pin connector. Or connect another drive on the 24 pin connector. Or...
I don't know anything about modded for Amiga ALPS floppies but it should be quite hard to fry R5 since it's a 12k pull-up resistor. Even if that resistor was...
It's been a couple of years since I designed this and I was unsure whether I tested external 3.5" floppy or not back then since all I needed it for...
Did you verify that the external disk receives 12V?
I can't reproduce your problems. That's why I asked what partnunbers you used for the chips. If yours are different from mine then that could be somethingfor me to try....
I have reproduced you problem now but with a later revision of my board. I made a Rev 2 that I never tested and therefore never published. I built it...
Can I reach you at the repairlab address on your facebook page?
The issue I was having when reproducing the problem was a floppy drive problem. I still can't reproduce the problem using good working floppies or Goteks. I have restored the...
The Revision you have should be Rev 1 too but the final version of Rev 1. The one I had was a preview of Rev 1 which didn't have all...