Ralph Bacon

With a W5100 shield and the standard Arduino UDP NTP client sketch ([https://www.arduino.cc/en/Tutorial/UdpNtpClient](url)) , the UIPEthernet library does not process (or get, in order to process) a response. Although it...

Compilation size is 106 bytes - what did I do?

4

I've tried various cores, from MicroCore, DIY ATTiny to Arduino standard and it won't go below 106 bytes. I've tried disabling everything I could (eg millis, micros, tone etc). How...

I'm using VS Code and PlatformIO. After a Deep Sleep on a 4Mb ESP32, I occasionally get messages like this: ``` 2022-07-01 16:35:09 --> E (24) esp_littlefs: partition "wtiogs" could...

TTGO v1.7.1 - pin 3v3 actually 3v8

1

The 3v3 pin on my TTGO v1.7.1 is measured as 3v854 on two multimeters. This voltage actually goes to the ESP32 chip, so I'm wondering two things: 1. Why is...

ATTiny167 Dev Board (Tindie)

1

Hello Spence I've ordered one of your ATTiny167 Dev Boards (Tindie Order #348935) because I've reached the end of the road regarding trying to program my blank ATTiny167 chips using...

UNO is reset on IDE startup and shutdown if port is open in Serial Monitor

4

Using Arduino IDE 2.0.0 the USB-attached Arduino UNO clone is reset upon starting up, or shutting down the IDE. Might be related to issue arduino/Arduino#11824. Running Windows 11, Arduino IDE...

Interesting development

8

I'm using the MicroCore but this PicoCore sounds interesting. Will it support all the Arduino language constructs? Rhetorical question, I shall find out in due course,no doubt. When it's done...