RB3rg
RB3rg
I doubt this "calibration" works just like that. It will need a reference, a specific voltage, and current to be used as a reference. @devicter have you ever tested this...
0xF8 is the broadcast address for Modbus so any device will catch it. 0x41 is the function of cal. Now comes the question, the device reads voltage and current. Calibration...
> Apparently, in the "Set parameters" option, you can see the calibration conditions for a module (but they are greyed out, so cannot be changed): >  > > Anyway,...
I can't wait on this; Shutter was removed from Ubuntu 19.04, yeah, I know we can install from 3rd repo but it will be dead soon. Need a replacement urgently....
You don't have to replace the relays, they are 12VDC. You might be asking about why to power with 12VDC instead of the regular 110VAC. The downside of 110VAC: -...
It will not.
Hi Stephen, Its not clear to me. Did you modify and just one relay works? On Tue, Dec 18, 2018, 16:58 DG0JG Hello > I would like to modify the...
Send me a detailed picture of the circuit board. Bottom side. I'm traveling overseas this week then I'll have a look once back home. On Fri, Dec 21, 2018, 07:55...
The boards I own (American type) have different pint out from yours. If you have the touch sensor at RC3 and RC1 then TRISC=%00001010 In the relay board, find out...
Yes we can do that, I don't have time then I show you how it works and how to do it, I even have pictures. Then you take care of...