PlusAzuki

When ClearURLs is not used, the link looks like this: https://message.bilibili.com/?spm_id_from=333.1007.0.0#/system , then the site can open normally. After using ClearURLs, the result looks like this: https://message.bilibili.com/#/%2Fsystem= , then the...

As dnsmasq did, “Bogus private reverse lookups. All reverse lookups for private IP ranges (ie 192.168.x.x, etc) which are not found in /etc/hosts or the DHCP leases file are answered...

最近发现的问题及一些建议

3

最近我发现我用的路由器开机并完成无线网络中继的时间比之前慢了一些，然后一看日志，一堆 daemon.notice hostapd: handle_probe_req: send failed 的错误，然而后面还是能完成无线中继。 如果想stubby那样给个trigger和triggerdelay 来指定一个特定的网络变化来引发本软件的启动甚至在此基础上加个延迟的话，会不会更好？

程序老是突然去世

22

编译给OpenWrt [版本号为OpenWrt SNAPSHOT r8917-ae622c9 / LuCI Master (git-18.363.34501-1d3a873)]的本程序[版本号为0.4.9.12-cd1249b]在openwrt上的错误日志: [2018-12-29 23:39:58] -> [Notice] Pcap_DNSProxy started. [2018-12-29 23:40:14] -> [Pcap Error] sit0: That device is not up [2018-12-29 23:40:14] -> [Pcap Error]...

看了下原项目的已经在上个月21号就更新了...这边有打算跟上一下吗？

[batman-adv]: B.A.T.M.A.N does not transfer data until you restart the interfaces set to batadv and batadv_hardif.

5

Maintainer: @simonwunderlich Environment: mediatek/filogic, Xiaomi Redmi Router AX6000 (OpenWrt U-Boot layout), OpenWrt SNAPSHOT r25589-f84ed09d2c Description: This my config below, I don't use VLANs, I also turned off dhcp for non-master...

netifd: can not add phyX-mesh to bat0 when device boot up

4

### Describe the bug netifd can not add phyX-mesh to bat0 when device boot up,more details here https://github.com/openwrt/routing/issues/1054 ### OpenWrt version r25589-f84ed09d2c ### OpenWrt release SNAPSHOT ### OpenWrt target/subtarget mediatek/filogic...