Peuqui

Thanks for reply! > If you have soldered the BMP on your t-beam then just leave it and get a new BPM280 and add it to your Raspi. GxAirCom won't...

Yep, thought about that too. But when I use the Stratux in the Gyrocopter, I guess, that the vibrations let disconnect the connectors due to not soldered.

`I do have a branch for STratux sitting on my computer that will also support getting baro from GxAirCom to Stratux but opted to not adding that in this version...

As I read correctly, it does have impact if altitude is from baropressure or GPS. The flight altitude depends on pressure altitude... And stratux makes a lot of computation to...

Thanks for that comprehensive explanation!

I found out recently, that waveshare displays are able to dim/shutoff the backlight with PWM: down in the FAQ: [https://www.waveshare.com/wiki/5inch_HDMI_LCD#Image](https://www.waveshare.com/wiki/5inch_HDMI_LCD#Image) [https://www.waveshare.com/wiki/Template:Raspberry_Pi_Documentation-GPIO](https://www.waveshare.com/wiki/Template:Raspberry_Pi_Documentation-GPIO) [https://www.waveshare.com/w/upload/5/56/PWM_control_backlight_manual.pdf](https://www.waveshare.com/w/upload/5/56/PWM_control_backlight_manual.pdf) I added this to my "/etc/rc.local" to enable...

Brilliant! I'll try it out. Edit: Works like a charm! Added following lines to "moonraker.cfg": [power Backlight] type: gpio pin: gpiochip0/gpio12 initial_state: on and following lines to KlipperScreen.cfg: [main] screen_on_devices:...

Hi and thanks for your fast reply! Sure, for most users, the position in the settings may be suitable. Unfortunately, I need to reconfigure my camera settings fairly often to...