PKav89

But different printers have different acelerations to produce "quality print" and "speedy print".

Hello! I might get this issue description wrong, but there is option Bridge Flow Baseline under Width & Flow. By default it is set to "Nozzle Diameter", which does twice...

> Using the nozzle diameter as the baseline let you enforce the same flow, whatever the condition are. Just change the flow% to reduce or increase the extrusion. I don't...

I connected to printer to change max speed, accelerations and some other settings. It's much faster than via menu. At least, Printrun should ask if user wants to turn off...

Well, yes, there is no reason for completely removing this feature. Prompt on exit like "Heater is on. Do you want to disable all heaters before exit?" would be nice...

What about option "Disable all heaters upon exit", which is on by default?

Motion controller mode is not possible on v1.2. Pins 20, 21 and 22 (VCC_IO, SD_MODE and SPI_MODE) are tied together on the PCB. It is possible to cut this VERY...

Well, according to a Watterott schematic https://github.com/watterott/SilentStepStick/blob/master/hardware/SilentStepStick-TMC5160_v14.pdf there is no pulldown resistor, so it seems to be possible to switch TMC5160 into motion controller just by cutting SD_MODE trace and...

I just tried cutting SD_MODE trace leaving SD_MODE floating and it seems to work. IOIN before cut (tied to VCC_IO) 0x30:00:00:52 IOIN after cut (SD_MODE floating) 0x30:00:00:12 So, bit 6...

I just tested motion controller, and yes, it runs OK with SD_MODE pin floating. Just cut the small trace on the board and TMC5160 switches into motion controller mode.