OriginaldCrypt

BTT Pi 1.2 OS image 3.0.0 -> GPIO reset (LOW) after shutdown?

2

Hi, I have a 3d printer with BTT Pi 1.2 and recently updated from 2.3.4 to 3.0.0. I use a GPIO (PI14, GPIO270, pin 33) for remote shutdown with BTT...

OS image v3.0.0 shows two wlan interfaces with two different MAC addresses

1

Hi, How is it possible that BTT-Pî 1.2 OS image v3.0.0 shows two wlan interfaces? ``` wlan0: flags=4163 mtu 1500 inet 10.0.0.xxx netmask 255.255.255.0 broadcast 10.0.0.255 inet6 fe80::1b7d:xxx:xxx:xxx prefixlen 64...

According to the [instructions of the Digital Level](https://wiki.openastrotech.com/OpenAstroTracker/Addons/DigitalLevel) for MKS GEN_L v2.1, a pin has to be soldered. I tried it in one board and I damaged the pad, the...

According to [changelog](https://github.com/OpenAstroTech/OpenAstroTracker-Firmware/blob/develop/Changelog.md) in an old firmware version, DEC autohoming via hall sensor was introduced: > V1.11.15 - Updates > > Add DEC Autohoming via Hall sensor (same as RA...