Orel-A
Orel-A
Yeah I think this should be there: ISR(WDT_vect) { wdt_disable(); }
> the wiring picture will tell you that doing that with wled only without extra hardware is a long shot I'm using a barebone ESP32 and it's working beautifully. Here...
Also happens on the original esp32, can't discover the created access point.
There is a bug when settings 0% on retract amount before wipe. It will treat it like we set 52% amount before wipe. On BambuStudio the bug isn't present.
> > There is a bug when settings 0% on retract amount before wipe. It will treat it like we set 52% amount before wipe. > > On BambuStudio the...
I can't test properly because it's also causing overextrusion and spiderwebs:  Same filament, same settings on BambuStudio comes clean! So I can't trust my tests with OrcaSlicer. Lets' revert...
> So it's present in the main build? If so, it's out of my wheelhouse. The problem is caused by this pull request: https://github.com/SoftFever/OrcaSlicer/pull/3888
We'll heat the nozzle after the G28 Z command since it can take some time if a previous print was tall and it's cause oozing on the middle of the...
You put the variable role_based_wipe_speed in the wrong file. It should be in the process files of the ke. And it's not an array.