OekoSolveMG
OekoSolveMG
I've attached the LogicAnaylzer to see if I can see anything on the Hardware level. As far as I could debug I can see 2 errors. One of which occurs...
I've added the 10 minutes I recorded as a .sr file in the .zip. [Session.zip](https://github.com/eModbus/eModbus/files/8968013/Session.zip) Really confused why it would be able to request, when the first receive hasn't been...
> I am looking at the .sr file next. What is your UART speed? Baud rate of 9600 > The LA graphics as you wrote are all pointing to some...
> You did not mess with the interval etc., or did you? 😉 No but I can add the log calls as well. Have to produce the errors again, because...
Same behaviour as before the 6th request always fails with reading 2 blocks each. ```cpp // Block 1 / Read 1 micros(): 75643485 interval: 3645 lastMicros: 55725944 // Block 2...
I'm using the TinyServer branch currently just so you know. Pretty sure there aren't any breaking changes tough.
> Can you spot the last byte that is reported as received in comparison to those on the LA dump? Could it be that the gap was detected a few...
Will do, need a second to sotter the pin tough. Will come back once I collected the data.
> Connect that pin to another LA channel? **RTUutils.cpp at both line 308 / 265** ```cpp digitalWrite(5, HIGH); // Buffer has space left - try to read another byte b...
> Retrospectively I now can see why I had to put seemingly arbitrary delays into my test sketch to get the >100 RTU tests going in a row. That would...