MattP
MattP
Using the same CM4 carrier board with a dedicated PCIe slot, I am able to boot normally via a USB enclosure with an NVME drive into PINN but when booting...
For lack of a better title, I was wondering if it would be possible in the future to set PINN to skip to the following device in the boot order....
I'd like to test out GloDroid on the Raspbery Pi CM4. The installer for Pi 4B only comes with an installer for SD cards but not the eMMC related files....
I'm trying to edit the config.txt file by adding "dtoverlay=dwc2,dr_mode=host" to enable the USB ports on the IO board to work in NOOBS, which works in Raspberry Pi OS and...
For those who are more versed in bare metal than I am, we are using: device_tree_address=0x1f0000 device_tree_end=0x210000 On the new d0 chips, do we know that the address location or...
Is there a setting that keeps PINN from probing drives other than the one it was booted on? For example, if I were to keep PINN as my main bootloader...
I haven’t used PINN in awhile and I had a bit of a face palm moment. When I started using Pi 4 originally, the eeprom was able to detect the...
Has adding the extended revision which can be obtained by mailbox command been discussed? https://github.com/raspberrypi/firmware/issues/1831 Bit 30 at 0 represents eMMC being present, 1 represents SD being present It would...
In the process of trying to port edk2 over to the D0 version of the Raspberry Pi 5, I discovered that the firmware framebuffer is interpreting RGB images with no...