Neutrino
Neutrino
can you send the error report? Hotspot turns on only during GPIO pin 12 is pulled LOW, during boot. So, make sure you use a pull resistor on GPIO pin...
Yes, that can be one of the problem, use a 10k resistor between the pin GPIO 12 and +3.3V and try again.
Could you send the corrected code in a temporary link? and which module you are using 12E or nodeMCU?
 The code you sent works fine, even though _handleSettingUpdate()_ fix isn't right. If your using NodeMCU, GPIO pin 12 corresponds to D6. So make sure that is pulled down...
I don't this that might help, because as far as I know "Honeywell SS49E" output's analog value at pin 3. Go with "A3144 hall effect sensor" this output's a digital...
**Code 550** "A 550 response code may be sent in response to any command requiring the server to access a local file. It is a permanent negative response, which means...
The build looks really good! Could you be more clear on "mission continuous play"?
Thanks for checking out the project! That can be because of the deprecated Email library. You might have to rewrite it. You can simply try IFFFT with esp Instead of...