NAPCAL
NAPCAL
BIGTREETECH-OCTOPUS-V1.0/Firmware/Klipper/Images/rpi_pinout.jpg is showing connecting 3.3V & 5V; this will cause issues with both boards. Ground, TX, RX is only needed, and 5V if the Octopus will be the only supply...
Step issues: BLtouch connector has no pins.  5V-V_bus header; only one pin showing, and it is not through the board.  Also, the Daig & Boot0 connection headers are...
The attached SKR E3-DIP-V1.0-PIN.pdf has the correct pins labeled for the TFT connector. [SKR E3-DIP-V1.0-PIN.pdf](https://github.com/bigtreetech/BIGTREETECH-SKR-E3-DIP-V1.0/files/5863745/SKR.E3-DIP-V1.0-PIN.pdf)
The Sexbolt might need a spring under the plunger to provide enough force to push the filament off of the nozzle when doing an automatic Z offset. The microswitch in...
Please provide support for STM32H743; this is a processor being used on the NEW BigTreeTech boards. CanBoot makes it easy to update without jumping through hoops or SD cards. I...
Add a user-definable device name that will be provided with the CAN bus ID when running flash_can.py -q Since the direction for using the CAN bus will head toward multiple...
Just found this out on my BTT Pro V1.1 using Marlin 2.0.6. Configuration_adv.h When selecting #define SDCARD_CONNECTION ONBOARD (Configuration_adv.h), the TF cloud device will not start the Blue led blinking...
Just found this out on my BTT Pro V1.1 using Marlin 2.0.6. When selecting #define SDCARD_CONNECTION ONBOARD (Configuration_adv.h), the TF cloud device will not start the Blue led blinking (when...
The current Klipper menuconfig shows the bootloader option when the current instructions does not show this option. To get the HC CAN board to work and provide a CAN bus...