NAPCAL
NAPCAL
> I'm giving up on the Canbus mod. Way more trouble than it saves in wiring. Huvud board is too big to fit anywhere on a Stealthburner anyway. Disappointing waste...
Working as of June 29, 2023
In another issue post when the EBB's changed to STM32G0B1 when asking about CAN-FD that G0B1 provides and if we needed to upgrade our CAN bus devices to CAN-FD; Arksine...
The issue called out is issues flashing the EBB42 with CanBoot. Flashing the Octopus (when using it as a CAN bus bridge, Klipper), you will not be able to do...
When having to flash via USB, CanBoot will have a different USB ID than Klipper. If you setup CanBoot with the quick double click of the reset to jump into...
I was going to try to flash the U2C V2 (STM32G0B1) with Klipper in CAN bus bridge mode to see if this would correct the issue, but BTT is using...
I think the issue is with the BTT U2C V2 firmware trying to use FDCAN for file transfers or not settling this up correctly since the rest of the bus...
Yes, it is an issue only with the U2C V2.x G0B1 and binary transfers.
I have checked both of my Pro boards and found no continuity issues with the SPI1_MISO or Drivers MISO. Here is what I checked on my F446 & H723. ...
@csdstudio78 Can you verify that your U27 and D41 are facing the same way as in my photo?