MrKapim
MrKapim
Oh yes important... The ioSender "freeze" and only close if I "reset" my cnc controler (the laptop "lost" the USB communication)
Yes, I checked the ports and is OK and tried other usb, not differences. I'm using SKR3 with STM32H743
ioSender 2.0.44 and no, there have been no driver changes. However, as I said at the beginning, ioSender opens normally and updates the information according to my firmware (it shows...
Yes. I opened the arduino and used the serial monitor to communicate and it's working. That's why I opened the conversation here...
Hi Terje, It's working. I use VM and reinstalled the VM tools package... Thank you again for your strong commitment and help.
I'm using the STM32H743 on BTT SKR3 EZ
I've made changes to MYMACHINE.H and now I have IOSender communicating but I get message 14 every time I send command to the axis (M3 or M4). I don't know...
An observation... I turn the set off and on again. On my RS485 interface, the RX led pulses 2 times and is off. When I open and connect the IOSender,...
I am sorry. Is the TX led that's pulsing not RX
Here my pins... 