Moobien
Moobien
This was the same Issue I reported a few weeks back. Card was completely fine.
I have had something similar. I will Tram my bed then set my z offset using a feeler gauge. then after G29 has run on a print the nozzle seems...
> on this line in creality's S1 firmware, they have BLTOUCH_DELAY configured. This may cause some differences? > > https://github.com/CrealityOfficial/Ender-3S1/blob/main/Marlin/Configuration_adv.h#L771 Could that be the difference between HS mode enabled/disabled in...
> There is no dynamic tree compat as of 1.18.2 yet. Yes then why do the Dynamic trees options show up in the forester ui if there is no compat...
> Because they register those properly. Better add the compat then :p
having this issue with the Steampunk Tavern/Town hall. Pasted in sptavern0 into townhall1 in the correct orientation on the schematic server. after the town hall was built in a single...
I thought Sam fixed this a year ago
not a bug. just bad luck can happen.
     
> @Moobien did you already replace all the broken racks in steampunk? We dont have issues with glitching racks with other styles where this had been fixed atm afaik? Nordic...