Mike4U

I don't have the EVTV CanDue 2.0 shield but have used due_can on a homemade shield with sw can. Due_can library doesn't know or care whether its sw can or...

I'm not sure what to do about this pull request I have with teachop's Flexcan https://github.com/teachop/FlexCAN_Library/pull/14 It adds another common speed 3333bps and a single wire can part to the...

@teachop Sorry, I can't get my head around using this github. I meant to post the above comment on pawelsky's, but it would be even better to have you back...

Closed issue #10 prematurely accidentally but will leave as is for now.

Added some info on this to the Teensy and Chevy SparkEV forums. https://forum.pjrc.com/threads/33306-SWCAN-bus-hack-allows-backup-camera-display?p=98031&viewfull=1#post98031

Sorry, back when I was working this I could have told you in painstaking detail but apparently did not properly document my procedure. (My early alzheimer's doesn't help) I started...

Sorry didn't want to close (again)

Just want to point out some observations on the can-timing spread sheet: 1. Where is this from, its similar to CAN_setup1 but gets different results. Maybe I didn't setup everything....

This problem persists on T4, T4.1 on all ADC DMA examples with new Arduino 1.8.15 Teensyduino, Version 1.54 [https://forum.pjrc.com/threads/64432-Teensy-3-5-ADC_DMA-example-error?p=266054&viewfull=1#post266054](https://forum.pjrc.com/threads/64432-Teensy-3-5-ADC_DMA-example-error?p=266054&viewfull=1#post266054) shows solution except the sketch too needs mod in the same...

The error code return alway returns 0. The code says: // @TODO: Return error if data is too big. I'll make this a new issue