Martius108
Martius108
Great, thanks for your quick response! Btw. how does it work with the oscillator calibration? Just uncommenting the line for the calibration?
Thank you. The voltage value of my USB tester is around 0.1 V lower than it should be and the current is around 0.03 A higher than it should be....
Thank you very much.
Thank you. The wiring was ok, but under the magnifying glass I found a little shortcut at the INA chip. It’s not so easy to hand solder a SOT-23 :)
Thank you. I tried oled.clearToEOL(); but there are still old pixels visible. The bicycle wheel is not turning fast, so I need to have the old values on the display...
I also tried it with an extra function but this is not working either .. `// Tachometer ATtiny85 #include #include #include const int hallPin = PB4; // Digital pin hall...
There are three types of hearing loss: a drop or loss of low frequencies, drop of high frequencies or the drop of the whole spectrum (or a combination of these)....
Ok, thank you! I‘ll try this .. and good point with the clipping; I completely overlooked this one.