MacGH23
MacGH23
Since I only use one Adapter for the 4 Pads, it is OK for me to use the reset Button to update the FW ;-)
1st: 2 are working without problems, but only with exact 2. If I attach only 1 I get an Unknown USB Error And also no Joystick is working any longer....
Look like you used the current main which break the support of the 3D Pro
Hi, Thanks for the update. It is working better :-) 1-2 are working without problems. With 3 attached sometimes the game control panel is not coming up. I see the...
@dferyance If you need 2 more for testing, the old ones are quite cheap to get in Germany. If you like I buy 2 pcs and send it to you....
You normally can not damage the USB port. You just get only 500mA I made some measurements with a USB-C power meter - Arduino alone: 60mA - +1 Gamepads: 75mA...
The newer USB normally should have a protection ;-) Just measured again with 3 other Gamepads. More or less the same result. I try to setup a Osci measurement next...
Had the same Idea and also added an add. 5V power to the last one. Same result. Rapid blinking. I measure 5V on the VCC of the MicroUSB version.
Made a Osci measurement, since forgot the modified cable for the lab, I did only some voltage measurements. The 5V raises within 5-7ms to full 5V without any drops. 100%...
The latest fix for the 3D Pro fixes also the non working 3dpro with the daisy chain mod https://github.com/necroware/gameport-adapter/issues/85 I copied the 2 lines in the Hidjoystick.h and now 3D...