MATEKSYS
MATEKSYS
> In my testing on the bench I was able to get it to boot by decreasing the value of the pullup resistor on the receiver I have (which is...
> Thanks, @MATEKSYS! However, I found that 12K on CH1 was not sufficient when using 2x servos which each had 12K resistance to ground when measuring their (disconnected) signal pin....
@diankurus CH5(AUX1) is just a 2-position channel https://www.expresslrs.org/2.0/software/switch-config/#aux-1-all-modes
> Faced same issue. Why it was even merged if it evidently doesn't work? @MATEKSYS @DzikuVx any thoughts, guidelines, deadlines? Your ESC doesn't support multishot? oneshot?
We have sent M10Q-5883 and CAN-L431 samples to some BF devs in last Nov. CAN-L431 node with AP_Periph fw supports GPS/Mag MSP output if connnecting it with M10Q-5883. No idea...
looks like most of definitions are copied from MatekH743, even the APJ_BOARD_ID 1013 is copied. :-)