Lucky Resistor

@murk-sy Regarding the issue with removing the Bowden tube, I hope one 3D-printer manufacturer will implement the following filament switch system: 

Hello, First of all, I apologize for my late response. I've encountered a similar issue with one decoration produced by Pimoroni, where some LEDs stayed on as if the microcontroller...

I had similar issues, but my PrusaXL printer is connected via Ethernet. - In one case, the printer skipped some gcode commands while printing an infix. This resulted in a...

Adding support for multiple wipe towers would greatly improve print quality and make more complex multi-material prints possible. This would be especially useful for printing with different nozzle sizes or...