LAZER555
LAZER555
I put 4 in the homing speed, 8 is too fast. For now it works :) Thank you
Ok it crashed again, when i launched the print before homing. The bed was hot, the homing speed was 4. And it crashed before starting the print
I calibrated it with the bed at 80 and it's working for now :P
I have the same problem, my version is V1.1 pandapi3d.com What i found out of my observations: 1. You should calibrate only when hot (bed and maybe nozzle too). 2....
> > 4. I made calibration with 0.1 from the bed and the numbers were good, but it's still scary to home the printer. > > you can try to...
Okay, it crashes into bed 1 time out of 5. I asked mellow store for a replacement, and they sent it. One question, why can't it stop when homing, when...
> there is some limitation of klipper, but maybe it's possible so I am resuming to develop the code in klipper for the real time adjustment. please do not use...
i have the same thing, and when i try to make the klipper.bin i get this error Preprocessing out/src/generic/armcm_link.ld Building out/compile_time_request.o Too many message ids make: *** [Makefile:84: out/compile_time_request.o] Error...
I tried to make without bdsensor, and it worked. It means something in your update was faulty Building out/compile_time_request.o Version: v0.12.0-180-g79930ed9 Linking out/klipper.elf Creating hex file out/klipper.bin Can you please...
> seems that the mcu didn't flash success or check if there is BD_sensor.o on the SSH while run compile command `make ` there is a BD_sensor.o , but there's...