Kristoffer Lippert
Kristoffer Lippert
> So far, around 95% of these kinds of issues I've seen with users are due to incorrect settings on the step pulse delay. Check the manual for your drivers...
> @Klippert When an axis direction changes, this delay comes into picture. Your motor drivers need some time when that axis changes direction that should be specified in their datasheets...
I reajusted the controllers to the following settings. Now i have a problem that when i reach an endstop, the decelleration is too abrupt. is there a way of letting...
Hello Again, I just did a test where I lowered the acceleration on the X and Y Axis to 25mm/sec2 - from 250mm/sec2. This produced holes with much tighter roundness...
Hello, First a correction. 400mm/sec was meant to be 400mm/min 😂 Thanks for the suggestion on the planner buffer. I’ll try increasing that. Would the deceleration on homing be an...
Yes. That’s good points. I guess one could set a number of steps to decelerate over after limit switch triggering. If one is using a mechanical limit switch it’s a...
Hello again, Just to wrap up this thread, I've been running with lower accelleration settings for a couple of weeks now, and that seems to work pretty well. I have...
No problem. Im intrigued to see if there is an actual issue or its just me tor. 24. okt. 2024 kl. 07.53 skrev Terje Io ***@***.***>: > This will have...
Hello terje, thanks for looking into the issue and thanks for the fix. Now it’s me that is away - but I’ll be back after Christmas, then I’ll find an...