Jason Christensen
Jason Christensen
When you calibrate the BDsensor make sure the nozzel in touching the bed... this sets the BDsensor z to 0. [BDsensor] z_offset remains at 0. Then it is my understanding...
I'd check and test the probe. I had a similar problem, inconsistant probe accuracy. Calibrated and triggered fine, but would play up when in actual use whether the bed was...
> This error means that it detected the first point in calibration data is too large(1015) by command M102 S-5, it happens in calibration when the distance of coil to...
IMO two screws is not required on the sensor. Simply model a rib at least 1/3 around the sensor and it will be keyed in place. The sensor will not...
@mneuhaus I totally agree. Would be good for BTT to supply an up to date stp/stl file of the unit and all the cad drawings showing the thickness as well,...
Thanks for the quick reply Mark, I note that point 1 of RTL installation instruction states "This feature only works with the BDsensor and Z motors are connected in the...
Fair enough, makes sense. Thanks. I will need to think about my setup, maybe I have to add the long cable back to the toolhead to have the BDsensor connected...