KanG00

I have USB to UART converter connected to board only + USBASP AVR programmer if needed. What kind of programmer would I need to recover it ?

I’ll check this promissing tool first for sure, but could you please advice the exact command that I should use for my chip? Don’t wan’t to get it worse :)...

After several failed tries I've moved to raspberry and it seemed to work, but when connecting again to terminal it behaves exactly the same: > burn $ ./hi35xx-tool --chip hi3518ev200...

ok, I've managed to install universal u-boot and stop the boot process. How can I define IP address now to download and flash u-boot again? > tftp 0x82000000 openwrt-hi35xx-18ev200-u-boot.bin Hisilicon...

I know but with current bootloader I do not have TFTP available as it is not able to connect to Ethernet PHY adapter. I can copy the files on SDCARD...

I've managed to recover the chip finally by using openwrt-hi35xx-18ev200-u-boot.bin u-boot supporting SD card read as universal u-boot was not able to make use of ethernet port in my device...

I used u-boot given by @widgetii couple posts above. Where is the latest u-boot and firmware to download? I’m having huge problems with self compilation

Sorry for this lame question, but how to flash my camera with this firmware compressed file? I was able to flash it via SERIAL-UART converter but using root and kernel...

I get wrong SoC error: > Kernel Update kernel from /tmp/uImage.hi3518ev200 sh: od: not found Wrong SoC! Aborting. but SoC is correct and defined as env. below ipctool output: ./ipctool...

I've managed to install the firmware by extracting files from link and flashing through SD card. But now after booting up I have read-only system that is not allowing me...